EEPROM
The EEPROM is located on the SBC196 board and stores the cycle parameters. In the event that a board must be changed, removing this chip from the old board and inserting it into the new board will preserve the cycle parameters.
EEPROM Location and Jumper Installation
SB196Jumpers
Jumpers must be installed at locations J 10 and J 12 on the SBC 196 board. A jumper must NOT be installed in location J3 as this will cause the microcontroller to remain in reset and the control board will not operate.
Have questions?
Have a question or having difficulties? Talk to Dave Schall, our PRIMUS sterilizer expert who is here to assist you anytime at 877.679.7800 extension 1212 or email at dschall@spire-is.com.